INTRODUCTION

The types RSRV and RSRT are centrifugally lift-off sprag type high speed backstops with integral torque limiter. Please refer to the RSCI design on catalogue pages 76 to 79 for complementary information on Stieber centrifugally lift-off sprag type backstops.

The high quality oil through-impregnated friction linings ensure a consistent and reliable slip torque even when not in operation for a long length of time. The slip torque is factory
pre-set to the application requirements.

These assemblies are primarily intended for installation on multiple drives where two or more backstops share the reverse load, such as on large inclined conveyors.

The RSRV is the pure load-sharing version. No mainte-nance and adjustments are necessary.

In addition, the RSRT can be progressively released under load by a mechanical device. Alternatively we can offer a hydraulic release solution for a fully controlled safe release
procedure.

The slip torque should be set 20% higher than the maxi-mum static return torque including overload conditions.

These units are not bearing supported internally. The outer member must be centred on the machine housing.

Concentricity and run-out limits must be observed.
 

NOTES 1) Maximal slipping torque. A lower slipping torque can be set. 2) This minimum allowable overrunning speed n min should not be reduced under continuous operation. Possible reduction of this minimum speed on request. 3) Maximal speed, inner race overruns Keyway to DIN 6885.1 4) Tolerance +2 When ordering, please specify direction of rotating seen from arrow »A«. »R« Inner race overruns in clockwise direction. »L« Inner race overruns in counter clockwise direction. » Refer to mounting and maintenance instructions pages 16 to 19

MOUNTING EXAMPLE